The rabbit knows the way back.
Last update: 31-Jan-2014 06:54 UTC
ntptrace [ -n ] [ -m maxhosts ] [ server ]
ntptrace is a
perl script that uses the
ntpq utility program to follow the chain of NTP servers from a given host back to the primary time source. For
ntptrace to work properly, each of these servers must implement the NTP Control and Monitoring Protocol specified in RFC 1305 and enable NTP Mode 6 packets.
If given no arguments,
ntptrace starts with
localhost. Here is an example of the output from
% ntptrace localhost: stratum 4, offset 0.0019529, synch distance 0.144135 server2ozo.com: stratum 2, offset 0.0124263, synch distance 0.115784 usndh.edu: stratum 1, offset 0.0019298, synch distance 0.011993, refid 'WWVB'
On each line, the fields are (left to right): the host name, the host stratum, the time offset between that host and the local host (as measured by
ntptrace; this is why it is not always zero for
localhost), the host synchronization distance, and (only for stratum-1 servers) the reference clock ID. All times are given in seconds. Note that the stratum is the server hop count to the primary source, while the synchronization distance is the estimated error relative to the primary source. These terms are precisely defined in RFC 1305.
Sets the upper limit of the number of hosts to check (default: unlimited).
Turns off the printing of host names; instead, host IP addresses are given. This may be useful if a nameserver is down.
This program makes no attempt to improve accuracy by doing multiple samples.
Was this page helpful?
Glad to hear it!
Sorry to hear that.